Free Printer Resetter

Thursday, October 30, 2008

ERROR CODE MP150 MP160

E9 The connected digital camera / video camera does not support Camera
Direct Printing
E14 The Ink cartridges whose destination are wrong
E15 Ink cartridge is not installed E16 - Ink remaining is unknown
E16 -E19 Failed to scan head alignment sheet
E22 Carriage error
E23 Paper feed error
E24 Purge unit error
E25 ASF(cam) sensor error
E26 Internal temperature rise error
E27 Waste ink absorber full or platen waste ink absorber full
E28 Ink cartridge temperature rise error -
E29 EEPROM error
E33 Paper feed position error
E35 15 USB Host VBUD overcurrent error - USB
E37 17 Abnormal motor driver error
E40 20 Other hardware error
E42 22 Scanner error

Wednesday, October 22, 2008

Download resetter for stylus Color 580

this time i share for epson stylus Color 580
Download resetter for stylus Color 580

source at http://dsacme.blogspot.com/

Tuesday, September 23, 2008

about MP390 Waste ink tank full

The pad that was mentioned (15cm by 5cm and 2.5cm wide) is almost lying on the plastic base at the very bottom of the printer and you quite literally have to remove almost everything to get to it (I ended up breaking it as was convinced I would never remember where all the bits and cables would reconnect to, but I wanted to at least see this pad mentioned before giving up). The pad itself was only 20% covered with ink the rest being white and dry. Could probably have just reset printer and left it and been fine for years yet! The chance of it spilling over and out of the area it is in is very slim would have to have a lot more than the 3 years of use I have given mine. The pad was barely damp in the most soaked end and I was prepared to soak in Isopropyl Alcohol and dry it if I had been able to get it back together.

If anyone wants to attempt this again, suggest you cut open from the base ie. there is a groove in the base near front of printer like a letter d with a thinner part and a thicker part for the round part of the d. Start at the top of the thicker part of the D and cut towards the rear 10cm then parallel to the rear for 15-20cm then back to the long part of the d for 10cm and break this section off. Use a good box cutter. Find and clean the pad using alcohol. Then place back and tape it shut (can't see it under there anyway)...then reset and go! Had I known what I know now that is what I would have done.